Blog – Page 7 – CJ ROMBOLD

November 22, 2020 0

MOPAR 273

Before the 340 there was the 273. These were available in Darts, Chargers, and Barracudas as well as other models. This one came to the shop for a stock rebuild. Most came with a two barrel carburetor but this one has a four barrel manifold. We swapped the Carter AFB 480 for a Edelbrock 600.…

admin58

November 16, 2020 0

429 Super Cobra Jet

This 429 was brought in for a stock rebuild and will be up on the engine dyno next week. We are hoping for 400 HP. Check out the video on our Facebook page @ https://www.facebook.com/CJRomboldEngines/.

admin58

November 10, 2020 0

Ford 302

Our shop rebuilt the bottom end on this 302. The customer built the top end and then brought it to us for engine dyno break in and to check for leaks. This engine will be equipped with a PowerDyne super charger and installed in a 1992 fox body Mustang.

admin58

October 31, 2020 0

469 Big Block Blower Engine

This Big Block Chevy made 809 HP and 714 TQ with 10 lbs of boost and two Holley 650 carburetors. The customer is installing an injection system which should put this 469 CI over 1000 HP. This is a Bow Tie block with Brodix heads and a Weiand 871 Blower. Check out our engine dyno…

admin58

October 28, 2020 0

Sleeper Nova

Check out this cool four door 66 Nova. Of course it has a LS swap with a manual transmission. This car can easily burn the rear tires off in 1st, 2nd, and third gear. Came in for dyno tuning. Got to love the sleepers!

admin58

October 26, 2020 0

466 Big Block Chevrolet

This BBC made 495 HP & 512 TQ on pump gas! A hydraulic flat tappet cam, Edelbrock intake, and a Holley carburetor were some of the modifications. Check us out on Facebook!

admin58

October 11, 2020 0

Corvette Convertible

This great looking driver was brought in by the customer for a new 600 Edelbrock carburetor, an electronic pickup for the distributor, new plugs and wires. This will make this 283 CI four speed car perform better and be more reliable. Schedule your car today!

admin58

October 5, 2020 0

Olds Rebuild

Customer brought this engine in because of a noise. Turns out it had a case of piston slap. It is now a 495 CI with a Edelbrock Intake, Quick Fuel Carburetor, Mild Hydraulic Cam, and Stock Heads. On the Engine Dyno it made 417 HP and 540 LBS TQ.

admin58

September 25, 2020 0

484 Stroker Hemi

You may not know but people come in and rent our Engine Dyno to test builds or an engine purchase. This way the customer knows all is well before installation. This MOPAR Hemi is such an example. This engine was built by someone else and the owner wanted to check for leaks and performance before…

admin58

September 9, 2020 0

1966 Chevelle

This beautiful green 66 Chevelle with a 454 our shop built came in for a few dyno pulls. After a carburetor re-jet it produced 401 HP and 420 TQ.

admin58